Enter the four-digit master code for this system – or whatever length matches your particular model’s owner-assigned code from its factory settings - followed by 5 (for example: 1234-5).ģ. This will allow access into programming mode – typically starting with “20.”Ģ. Start by entering “Installer Code” on the keypad of your alarm system. Once you have located the master code, follow these steps:ġ.
If you are having difficulty locating the master code, refer to your alarm system’s user manual or contact Honeywell customer service for assistance. The master code is typically four digits long, but it can range from three to seven digits depending on which model of Honeywell alarm system you own. This code is required in order to reprogram your system. Before resetting the system, you must first locate the master code. Once you’ve assessed the situation, you can begin the reset process.Īfter a power outage, you will need to reset and reprogram your Honeywell alarm system in order to regain access and functionality. If any of your equipment is damaged or has been moved, try to put it back in its original position before continuing. First, make sure that all of your security equipment is still accessible and functional. Before you attempt resetting your Honeywell alarm system after a power outage, it is important to prepare for the process. If you want to turn off / decommission your burglar alarm yourself, then follow the following video. If you want a professional engineer to fix your alarm system, get in touch with the SmartSecurity team. At this point your alarm is decommissioned. The bell will usually ring for 20 minutes and then stop. You can’t do anything about this – unless you get an engineer to do the full decommissioning for you. At this point the outside bell will start ringing.
Locate the battery inside of the alarm panel, and remove the x2 terminal wires – red and black. Now, open the front of your main alarm panel – by unscrewing the screws. Your alarm will now have no mains power going to it, and it will be running off the battery only.
Remove the fuse from inside – by levering open the small compartment in the front of the box, and prizing the fuse out. Now locate the alarm fuse spur – this is usually located next to the alarm panel. If you don’t use your burglar alarm system or want to completely turn off the power to it, then you will need to do the following in order to turn the power of / decommission it:įirst locate your main alarm panel – this is normally a mid-sized white box attached to a wall.
0 kommentar(er)
